60 lines
2.4 KiB
Markdown
60 lines
2.4 KiB
Markdown
# Vulpes
|
|
An ESP32-based radio orienteering controller. This repo is for
|
|
the code. There will be another repo for the schematic and PCB
|
|
design.
|
|
|
|
## What
|
|
Radio orienteering, or amateur radio direction finding (ARDF) is a
|
|
sport where people run around and look for hidden transmitters. One
|
|
necessary component is a controller on each transmitter that tells
|
|
it when and what to transmit.
|
|
|
|
This is my attempt at a simple, easy-to-use controller with a low
|
|
parts count. Rather than programming a microcontroller and/or
|
|
using DIP switches, time delays, and sync cables, the ESP32 development
|
|
board lets you set up each controller using a web browser (e.g., on your
|
|
smartphone or tablet).
|
|
|
|
The [ARRL ARDF page](https://www.arrl.org/amateur-radio-direction-finding)
|
|
is an OK starting point for learning about radio orienteering, but
|
|
there are probably better ones.
|
|
|
|
## Hardware
|
|
I designed a simple custom printed circuit board (PCB) to make
|
|
assumbling this controller easy to do. The repo for schematic and
|
|
board design is here: [link to new repo].
|
|
|
|
Because the ESP32 doesn't track time when it is powered off, and
|
|
I wanted to avoid specific delays (e.g., push a button two hours
|
|
before an event starts), an additional real-time clock (RTC) is
|
|
included. The RTC runs on a watch battery to track time when the
|
|
controller is not powered on.
|
|
|
|
## Software/Firmware
|
|
Power on the controller by plugging in a micro-USB cable to a 5V
|
|
source (e.g., computer or battery pack). After the device is powered on,
|
|
it will start an internal webserver and set up a wireless network called
|
|
"vulpes."
|
|
|
|
Connect to the "vulpes" wireless network and use a web browser to navigate
|
|
to `http://192.168.0.1` (note "http" not "http**s**"). You will see the
|
|
settings below. Note that you will not be able to access the Internet while
|
|
connected to this network, and each controller sets up a separate network.
|
|
|
|
### General Settings
|
|
|
|
### Cycle Settings
|
|
|
|
### Network Settings
|
|
#### Access Point
|
|
When using as a wireless access point, the network SSID is "vulpes"
|
|
with no password. Navigate to http://192.168.0.1 to access webform.
|
|
|
|
## License
|
|
GNU GPLv3. See `LICENSE` file for details, and
|
|
https://choosealicense.com/licenses/ if you're like me and don't
|
|
understand all of this stuff.
|
|
|
|
## Acknowledgments
|
|
Special thanks to [Mark Fickett](http://www.markfickett.com/) for his
|
|
[arduinomorse](https://github.com/markfickett/arduinomorse) library. |